[Jun 20, 2026] 300-610 Dumps PDF and Test Engine Exam Questions - Free4Dump
Verified 300-610 exam dumps Q&As with Correct 330 Questions and Answers
NEW QUESTION # 66
Refer to the exhibit.
What must be the default gateway of the servers in EPG Web?
- A. subnet address of L3Out
- B. subnet address of BD1
- C. subnet address of BD2
- D. NAT appliance
Answer: D
NEW QUESTION # 67
Drag and Drop Question
Drag and drop the configurations from the left onto the correct policies on the right.
Answer:
Explanation:
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/gui/config/guide/2-
2/b_UCSM_GUI_Configuration_Guide_2_2/
configuring_network_related_policies.html#task_7F03A03C719A4A44B8ACFAD73AADC73C
NEW QUESTION # 68
An engineer is implementing a Cisco UCS environment. The system must aggregate all vNICs into a single policy and consistently enforce node disassociation across the cluster. Which two UCS policies meet these requirements? (Choose two.)
- A. firmware policy
- B. LAN connectivity policy
- C. boot policy
- D. scrub policy
- E. vNIC policy
Answer: B,E
NEW QUESTION # 69
An engineer must design a VXLAN EVPN network. The solution should optimize broadcast, unknown unicast, and multicast (BUM) and short BUM replication, and use PIM anycast RP. Which solution should be included in the design?
- A. ingress replication
- B. PIM sparse mode
- C. PIM dense mode
- D. head-end replication
Answer: B
NEW QUESTION # 70
Drag the appropriate from the left onto the current UDLD modes of operation on the right.
Answer:
Explanation:
NEW QUESTION # 71
A storage administrator receives reports of network delays when database software attempts to access the storage array.
The virtual machines that host the database software are installed on different rack servers connected to the Cisco UCS Fabric Interconnect domain. The existing SAN switches are connected to the Fabric Interconnects using two 8 Gb port-channel interfaces to connect the storage array. The storage administrator has decided to deploy iSCSI storage with four 10 Gbps interfaces connected to the Cisco UCS Fabric Interconnects.
Which deployment type resolves the problems with storage contention?
- A. iSCSI storage appliance on Cisco UCS Fabric Interconnect uplink trunk port
- B. iSCSI storage with Cisco UCS Fabric Interconnect in the virtual port-channel mode
- C. iSCSI storage with Cisco UCS Fabric Interconnect using an appliance port
- D. iSCSI storage appliance on Cisco UCS Fabric Interconnect in the storage end-host mode
Answer: A
NEW QUESTION # 72
A midsize corporation with significant data-storage requirements is planning to deploy RFC 3720- based technology in its data center to provide efficient and reliable block-level storage access to servers. The corporation requires a robust solution with optimal performance, load-balancing, and fault tolerance. The solution must use multiple network paths to optimize bandwidth usage and provide redundancy LACP has already been enabled on the data-center switches.
Which two actions must be taken to accomplish the goal? (Choose two.)
- A. Configure iSCSI MPIO software on the hosts
- B. Disable jumbo frames on the data center switches
- C. Configure the iSCSI initiators and targets to use a single network path
- D. Implement MPIO with redundant network paths
Answer: A,C
NEW QUESTION # 73
Which mode must be enabled on a Cisco UCS Fabric Interconnect to connect directly to a storage array?
- A. FC end-host mode
- B. NPV mode
- C. NPIV mode
- D. FC switching mode
Answer: D
Explanation:
Switch mode is the traditional Fibre Channel switching mode. Switch mode allows the fabric interconnect to connect directly to a storage device. Enabling Fibre Channel switch mode is useful in POD models where there is no SAN (for example, a single Cisco UCS system connected directly to storage), or where a SAN exists (with an upstream MDS).
NEW QUESTION # 74
Which protocol prevents fiber failures from causing a Layer 2 loop in a dark fiber DCI?
- A. BFD
- B. MCP
- C. LLDP
- D. UDLD
Answer: D
Explanation:
Section: Network Design
NEW QUESTION # 75
An engineer is building a data center network with VXLAN EVPN. The requirement is to use multicast for the broadcast, unknown unicast, and multicast replication.
Which two VNI to multicast group mapping methods must be used to meet these requirements? (Choose two.)
- A. one VNI to one multicast group
- B. many VNI to one multicast group
- C. many VNI to many multicast groups
- D. one NVE to many multicast groups
- E. many NVE to one multicast group
Answer: B,E
NEW QUESTION # 76
An engineer installs a B-Series server in a Cisco UCS chassis that contains a pair of UCS-IOM-
2208XP I/ O modules. The full bandwidth of the I/O module must be utilized.
Which two elements should be used in this environment? (Choose two.)
- A. Cisco UCS VIC 1225
- B. Cisco UCS M81KR
- C. eight twinax cables from each I/O module to each fabric interconnect
- D. four twinax cables from each I/O module to each fabric interconnect
- E. Cisco UCS VIC 1280
Answer: C,E
Explanation:
2208 has 8 uplinks. VIC 1225 only works on C-Series UCS. M81KR has only 2x10G ports. VIC
1280 has 8x10G ports.
https://www.connection.com/product/cisco-vic-1280-dual-40gb-capable-2nd-gen-virtual-interface- card/ucs-vic-m82-8p/13785476
NEW QUESTION # 77
An engineer must design a disaster recovery solution for a Cisco ACI Multi-Site network. One requirement is that the applications must have seamless IP addressing across sites. The solution must also be highly resilient and support Layer 2 adjacency. Which design meets these requirements?
- A. Option A
- B. Option B
- C. Option D
- D. Option C
Answer: D
NEW QUESTION # 78
Drag and drop the technologies from the left onto the correct descriptions on the right.
Answer:
Explanation:
NEW QUESTION # 79
An engineer must interconnect customer data centers by using a 10-Gbps. unicast-only, Layer 3 circuit The requirement is to stretch the Layer 2 connection over the tunnel isolate STP traffic and create more than two million logical network segments Much solution meets these requirements?
- A. dark fiber
- B. IPsec over GRE
- C. OTV
- D. VXLANEVPN
Answer: B
NEW QUESTION # 80
The Cisco UCS environment must be connected to an existing SAN network that consists of several Cisco MDS 9000 Series Switches added to increase storage density. The solution must not exhaust the SAN network from the list of available domain IDs after connecting. Most of the SAN traffic must be mapped from the Cisco UCS blades to a specific group of the fabric interconnect ports. Which configuration must be deployed to meet these requirements?
- A. Dynamic Pinning and UCS Fabric Interconnect in Fibre Channel Switching Mode
- B. Static Pinning and UCS Fabric Interconnect in Fibre Channel End Host Mode
- C. Dynamic Pinning and UCS Fabric Interconnect in Fibre Channel End Host Mode
- D. Static Pinning and UCS Fabric Interconnect in Fibre Channel Switching Mode
Answer: B
Explanation:
Fibre Channel End Host Mode on the UCS Fabric Interconnects prevents each FI from consuming its own SAN domain ID, preserving your limited domain pool on the MDS fabric.
Static Pinning lets you bind each server blade's vHBA to a specific FI FC uplink port (or port group), ensuring that the majority of traffic from UCS blades egresses exactly where you intend it, without dynamic load-balancing changing paths.
NEW QUESTION # 81
A Cisco UCS chassis with several blade servers, a pair of IOMs, and a pair of Cisco UCS Fabric Interconnects are installed in a data center.
Which two high-availability architectures are recommended between the IOMs and fabric interconnects? (Choose two.)
- A. Any combination of one to eight links are supported to be used between each IOM and fabric interconnect.
- B. Straight and cross-connect links should be used between the IOMs and fabric interconnects to offer higher availability.
- C. One, two, four and eight links are supported to be used between each IOM and fabric interconnect.
- D. The IOMs are connected with multiple straight and cross-connect links toward a pair of nonclustered fabric interconnects.
- E. IOM is connected to the fabric interconnect that is acting as fabric A, and IOM B is connected to the fabric interconnect that is acting as fabric B.
Answer: A,E
NEW QUESTION # 82
......
Cisco 300-610 Test Engine PDF - All Free Dumps: https://passleader.free4dump.com/300-610-real-dump.html